The RUBI SLAB TROLLEY, incorporates an extendable arm to facilitate the maneuver of loading and unloading of the ceramic sheet onto the WORK TABLE. With the arm folded, the SLAB TROLLEY allows you to go through the frame of a standard door without the need to perform complex or risky maneuvers, even when loading the transport system with material in its maximum format.

Equipped  with four rotating wheels (360º) with STOP & FIX braking and locking system, the SLAB TROLLEY  increases the safety in loading and unloading maneuvers. Thanks to the inclination of the transport system the SLAB TROLLEY becomes the ideal support to carry out the double gluing application task.

The SLAB TROLLEY has rubber bumpers at its ends to avoid possible impacts with the material or other elements.

With the SLAB TROLLEY the user can manipulate pieces of up to 140 kg of maximum weight and a format of up to 360 cm x 160 cm.

* The use of the SLIM EASY TRANS with the SLAB TROLLEY requires the mandatory use of the CROSSBAR SET (ref. 18819). The SLAB CART is supplied  disassembled and requires assembly for the first use

It is made up of a set of two reinforced, retractable and adjustable extruded aluminum guides, and two perpendicular crossbars that increases the robustness and stability of the whole assembly, especially when handling the heaviest pieces.

Thanks to the 6 gray rubber-based vacuum suction cups, the installer can adjust the fixing points, ensuring the handling of the porcelain tiles without fear of the tile surface being marked.

For correct use of the system, we must check that the surface of the sheet is clean of dust or other residues.

The set has 4 handles (2 per guide) that can be adjusted and positioned along the entire length of the guide, facilitating and adapting the SLAB TRANS HEAVY DUTY N to each moment and format.

The SLAB TRANS HEAVY DUTY N, by RUBI, incorporates a practical transport bag, equipped with wheels, to facilitate both the handling of the equipment, its storage, and its protection.

The SLAB TRANS HEAVY DUTY N transport system has been designed mainly for handling large format sheets with a thicknesses of 6 mm or more. These materials, in addition to posing a challenge due to their volume (surface), are very heavy, compared to the 3 or 5 mm sheets that, until now, we were used to. The design of the aluminum guides of the SLAB TRANS HEAVY DUTY N gives it a maximum load capacity of up to 170 kg.

It is important to note that this load capacity is total, so it cannot be exceeded in any case.

When talking about such high weights, and always bearing in mind that the weight of the transporter itself must be added to the handling, the fact of not exceeding the maximum single-person load should be taken into account. Therefore, in some cases, 3 or 4 operators will be necessary for safe handling.

The vacuum suction pad is a replacement for the RUBI SLAB TRANS HEAVY DUTY N. The use of this spare part makes it possible to replace the vacuum suction cups of the SLAB TRANS HEAVY DUTY N, maintaining, at all times, the original maximum load capacity of the system itself.

The vacuum suction cup allows the SLAB TRANS HEAVY DUTY N carrier to be attached to any type of surface (smooth, rough or structured). The vacuum suction pad for SLAB TRANS HEAVY DUTY N is sold separately and as a unit.

NOTE: Adding more suction pads to the SLAB TRANS HEAVY DUTY N does not increase the original maximum load of 170 kg.